Hit and run causes restricted weight limit on Brookport Bridge - WPSD Local 6: Your news, weather, and sports authority

Hit and run causes restricted weight limit on Brookport Bridge

Posted: Updated:
Brookport, IL - The Kentucky Transportation Cabinet (KYTC) is asking for your help. They're looking for someone who knows anything about an over-sized load that hit one of the support beams on the U.S. 45 Ohio River “Brookport” Bridge sometime in the last two days.
Spokesperson Keith Todd told Local 6 the structural damage prompted engineers to restrict the bridge to a 20-ton load limit effective immediately.

Inspectors went to the bridge Wednesday morning to check on a report that a section of railing had been damaged.  When they arrived they found something had hit a portion of the bridge superstructure.

“The Brookport Bridge was opened to traffic in 1929.  For many years it has been restricted to vehicles no more than 8 feet wide due to the limited deck width,” said KYTC District 1 Chief Engineer Mike McGregor.  “We believe it is likely that a truck crossed the bridge with an oversized load and struck the bridge support beam sometime in the last two or three days.”

Although they know there are reports that it may have been damaged for months.

"If anybody out there that has a picture of it, has a date on it, we'd really like to see that because we'd know more about what happened," said Todd.

Based on the damage assessment, McGregor said the driver of the vehicle would have known he or she hit something.

“It is alarming that someone would hit the bridge structure and not report it to 911 immediately,” McGregor noted.  “While several photos of the railing were posted to social media, there were no calls about the damage to McCracken 911 Dispatch or any of our facilities.”

The damaged beam is on the upstream side of the second span from the Kentucky shore. Several additional structural members along the northbound lane showed signs of being hit.

“This is part of a larger issue of truckers not obeying weight and load width restrictions,” McGregor said.  “While most truckers are honest and try to follow the law, all it takes is a few who run overweight or travel routes where they aren’t supposed to be to cause major damage to our infrastructure.”

The damage occurred to a “compression member” of the structure.  Had the damage been to a “tension member” of the structure it could have caused a failure of the span similar to the May 23, 2013, collapse of the Skagit River Bridge near Burlington, Washington.

With the 8-feet width restriction and 20-ton load limit on the Brookport Bridge traffic will be restricted to nothing larger than a small box truck.

“In addition to the posting of the 20-ton weight limit at the end of the bridge, we are asking for additional enforcement to assure that trucks stay off the bridge,” McGregor said.  “We are also asking for anyone with information about the damage to come forward.  This bridge has served this region well for 85 years, and this one incident could have forced the bridge to close or worse.”

The U.S. 45 Ohio River Bridge is scheduled to be closed for about a month this summer to allow the City of Paducah to construct a tunnel under U.S. 45 for the Greenway Trail.  KYTC engineers plan to use that closure to further evaluate the damaged beam and plan any needed repairs.

Also known as the Irvin S. Cobb Bridge, the U.S, 45 Ohio River Bridge is at McCracken County mile point 12.8.  The 10-span bridge carries approximately 5,000 vehicles across the river each day between Paducah, and Brookport, Illinois.

The 5,385 ft. structure at Ohio River navigation mile point 937.3 was opened to traffic in 1929.

Powered by WorldNow